Ideal fault code
Ideal FD: no water flow
Try the checks, then call an engineerChecked against 1 source ยท Updated November 2026
The boiler can't detect water flowing through it. BOXT's advice is to repressurise first.
Safe checks you can do
- Check the pressure gauge. Find the pressure gauge on the front or underneath the boiler. With the heating off and the boiler cold it should read roughly 1 to 1.5 bar. Anything under 1 bar is low. How to do this
- Top the pressure up if it's low. Open the filling loop slowly and watch the gauge. Stop at about 1.5 bar, close both valves fully, then reset the boiler. How to do this
- Make sure valves are open. Check that the valves under the boiler are open and that at least some radiator valves are turned on. Water needs somewhere to circulate.
- Reset the boiler, once or twice. Use the reset button or reset position on the dial, as your user manual shows. If the same code comes straight back after one or two resets, stop and book an engineer. How to do this
Common causes
- Low water pressure
- Closed valves
- A blocked filter or failed pump
When to call an engineer
If repressurising doesn't fix it, call an engineer.
Need an engineer?
For anything beyond the safe checks on this page, use a Gas Safe registered engineer. Find one near you, or check an engineer's ID, on the official Gas Safe Register (free helpline 0800 408 5500).
Can I fix Ideal FD myself?
Sometimes. Try the safe checks on this page first. If the code comes back, you need a Gas Safe engineer.
How to reset a Ideal boiler
Turn the dial to the reset position for about five seconds, then back. Newer models have a reset button. Only reset once or twice. A code that keeps returning is the boiler telling you something needs fixing.
Sources
We checked this code against the following, last reviewed November 2026. Codes can vary slightly between models, so your boiler's own manual is the final word.