Smell gas? Leave the property and call the National Gas Emergency Service on 0800 111 999, 24 hours.

Ideal fault code

Ideal L1: low water flow

Try the checks, then call an engineer

Checked against 1 source ยท Updated November 2026

What it means

Not enough water is moving through the boiler. BOXT lists it as low water flow and advises a reset first.

Safe checks you can do

  1. Check the pressure gauge. Find the pressure gauge on the front or underneath the boiler. With the heating off and the boiler cold it should read roughly 1 to 1.5 bar. Anything under 1 bar is low. How to do this
  2. Make sure valves are open. Check that the valves under the boiler are open and that at least some radiator valves are turned on. Water needs somewhere to circulate.
  3. Reset the boiler, once or twice. Use the reset button or reset position on the dial, as your user manual shows. If the same code comes straight back after one or two resets, stop and book an engineer. How to do this

Common causes

  • Low pressure
  • Closed valves
  • Air in the system
  • A failing pump or a blocked filter

When to call an engineer

If a reset and correct pressure don't clear it, an engineer should check the pump and filter.

Need an engineer?

For anything beyond the safe checks on this page, use a Gas Safe registered engineer. Find one near you, or check an engineer's ID, on the official Gas Safe Register (free helpline 0800 408 5500).

Can I fix Ideal L1 myself?

Sometimes. Try the safe checks on this page first. If the code comes back, you need a Gas Safe engineer.

How to reset a Ideal boiler

Turn the dial to the reset position for about five seconds, then back. Newer models have a reset button. Only reset once or twice. A code that keeps returning is the boiler telling you something needs fixing.

Sources

We checked this code against the following, last reviewed November 2026. Codes can vary slightly between models, so your boiler's own manual is the final word.