Smell gas? Leave the property and call the National Gas Emergency Service on 0800 111 999, 24 hours.

Worcester Bosch fault code

Worcester Bosch D4 271: temperature rising too fast

Try the checks, then call an engineer

Checked against 2 sources ยท Updated November 2026

What it means

The difference between the flow and safety sensors is over the limit, usually because water isn't circulating well.

Safe checks you can do

  1. Check the pressure gauge. Find the pressure gauge on the front or underneath the boiler. With the heating off and the boiler cold it should read roughly 1 to 1.5 bar. Anything under 1 bar is low. How to do this
  2. Make sure valves are open. Check that the valves under the boiler are open and that at least some radiator valves are turned on. Water needs somewhere to circulate.
  3. Bleed air out of the radiators. Radiators that are cold at the top have air in them. Bleed them with a radiator key, then check the pressure again, because bleeding lowers it. How to do this
  4. Reset the boiler, once or twice. Use the reset button or reset position on the dial, as your user manual shows. If the same code comes straight back after one or two resets, stop and book an engineer. How to do this

Common causes

  • Low pressure or air in the system
  • Closed radiator or boiler valves
  • A failing pump
  • Sludge or a blocked filter

When to call an engineer

If the pressure and valves are right and it keeps coming back, an engineer should check the pump and may suggest cleaning the system.

Need an engineer?

For anything beyond the safe checks on this page, use a Gas Safe registered engineer. Find one near you, or check an engineer's ID, on the official Gas Safe Register (free helpline 0800 408 5500).

Can I fix Worcester Bosch D4 271 myself?

Sometimes. Try the safe checks on this page first. If the code comes back, you need a Gas Safe engineer.

How to reset a Worcester Bosch boiler

Press the reset button (marked with a circular arrow or the word reset) and hold it for a few seconds until the display changes. Only reset once or twice. A code that keeps returning is the boiler telling you something needs fixing.

Sources

We checked this code against the following, last reviewed November 2026. Codes can vary slightly between models, so your boiler's own manual is the final word.