Worcester Bosch fault code
Worcester Bosch EA 229: flame lost while running
Try the checks, then call an engineerChecked against 1 source ยท Updated November 2026
The boiler lit, then lost the flame during operation. HomeServe lists a blocked condensate trap or strong wind blowing into the flue as possible causes.
Safe checks you can do
- Check the condensate pipe in freezing weather. The plastic pipe that runs from the boiler to an outside drain can freeze when it's below zero. Thaw it with a hot water bottle or warm water from a watering can, never boiling water, then reset. How to do this
- Look at the flue from outside. Check the flue terminal on the outside wall or roof isn't blocked by leaves, a nest, snow or something stacked in front of it. Don't touch, cover or take apart the flue itself.
- Check you have gas. Try the hob or another gas appliance. If nothing works, check the lever on the gas meter is in line with the pipe (that means on) and, on a prepayment meter, that you have credit.
- Reset the boiler, once or twice. Use the reset button or reset position on the dial, as your user manual shows. If the same code comes straight back after one or two resets, stop and book an engineer. How to do this
Common causes
- A frozen or blocked condensate pipe or trap
- Strong wind blowing into the flue
- Gas supply dropping out
When to call an engineer
If it keeps happening in normal weather, an engineer should check the condensate trap and flue.
Need an engineer?
For anything beyond the safe checks on this page, use a Gas Safe registered engineer. Find one near you, or check an engineer's ID, on the official Gas Safe Register (free helpline 0800 408 5500).
Can I fix Worcester Bosch EA 229 myself?
Sometimes. Try the safe checks on this page first. If the code comes back, you need a Gas Safe engineer.
How to reset a Worcester Bosch boiler
Press the reset button (marked with a circular arrow or the word reset) and hold it for a few seconds until the display changes. Only reset once or twice. A code that keeps returning is the boiler telling you something needs fixing.
Sources
We checked this code against the following, last reviewed November 2026. Codes can vary slightly between models, so your boiler's own manual is the final word.