Smell gas? Leave the property and call the National Gas Emergency Service on 0800 111 999, 24 hours.

Worcester Bosch fault code

Worcester Bosch E9 224: overheat safety cut-out

Try the checks, then call an engineer

Checked against 2 sources ยท Updated November 2026

What it means

E9 means a safety temperature limit has tripped. With cause code 224 it's the flue gas thermostat that overheated. With 219 the heat exchanger got too hot.

Safe checks you can do

  1. Let it cool down. Turn the boiler off and give it 15 to 20 minutes to cool before you reset it.
  2. Check the pressure gauge. Find the pressure gauge on the front or underneath the boiler. With the heating off and the boiler cold it should read roughly 1 to 1.5 bar. Anything under 1 bar is low. How to do this
  3. Reset the boiler, once or twice. Use the reset button or reset position on the dial, as your user manual shows. If the same code comes straight back after one or two resets, stop and book an engineer. How to do this

Common causes

  • Low water pressure or poor circulation (more common with 219)
  • A problem with the flue or combustion (224)
  • A faulty safety sensor

When to call an engineer

If you see E9 224, or E9 comes back after one reset, book a Gas Safe engineer. Flue overheating isn't something to keep resetting.

Need an engineer?

For anything beyond the safe checks on this page, use a Gas Safe registered engineer. Find one near you, or check an engineer's ID, on the official Gas Safe Register (free helpline 0800 408 5500).

Can I fix Worcester Bosch E9 224 myself?

Sometimes. Try the safe checks on this page first. If the code comes back, you need a Gas Safe engineer.

How to reset a Worcester Bosch boiler

Press the reset button (marked with a circular arrow or the word reset) and hold it for a few seconds until the display changes. Only reset once or twice. A code that keeps returning is the boiler telling you something needs fixing.

Sources

We checked this code against the following, last reviewed November 2026. Codes can vary slightly between models, so your boiler's own manual is the final word.