Smell gas? Leave the property and call the National Gas Emergency Service on 0800 111 999, 24 hours.

Worcester Bosch fault code

Worcester Bosch 2970: pressure dropping too fast

Needs a Gas Safe engineer

Checked against 2 sources ยท Updated November 2026

What it means

On the 8000 Style, the system pressure is falling quickly, which usually means a leak.

Safe checks you can do

  1. Check the pressure gauge. Find the pressure gauge on the front or underneath the boiler. With the heating off and the boiler cold it should read roughly 1 to 1.5 bar. Anything under 1 bar is low. How to do this
  2. Top the pressure up if it's low. Open the filling loop slowly and watch the gauge. Stop at about 1.5 bar, close both valves fully, then reset the boiler. How to do this

Common causes

  • A leak in the boiler, pipework or a radiator
  • A faulty pressure relief valve
  • A failed expansion vessel

When to call an engineer

Pressure falling quickly means water is escaping somewhere. Top up to get heat back, then book an engineer to find the leak.

Need an engineer?

For anything beyond the safe checks on this page, use a Gas Safe registered engineer. Find one near you, or check an engineer's ID, on the official Gas Safe Register (free helpline 0800 408 5500).

Can I fix Worcester Bosch 2970 myself?

No. Apart from the simple outside checks here, this needs a Gas Safe registered engineer.

How to reset a Worcester Bosch boiler

Press the reset button (marked with a circular arrow or the word reset) and hold it for a few seconds until the display changes. Only reset once or twice. A code that keeps returning is the boiler telling you something needs fixing.

Sources

We checked this code against the following, last reviewed November 2026. Codes can vary slightly between models, so your boiler's own manual is the final word.