Worcester Bosch fault code
Worcester Bosch FD 231: power interrupted
You can usually fix thisChecked against 2 sources ยท Updated November 2026
There was a mains power interruption, or the reset button was pressed by mistake. Press reset again.
Safe checks you can do
- Turn the power off and on. Switch the boiler off at the fused spur on the wall for a few seconds, then back on. This restarts the electronics.
- Reset the boiler, once or twice. Use the reset button or reset position on the dial, as your user manual shows. If the same code comes straight back after one or two resets, stop and book an engineer. How to do this
Common causes
- A brief power cut or interruption
- The reset button pressed by mistake
When to call an engineer
If it happens often without a power cut, an engineer or electrician should check the supply to the boiler.
Need an engineer?
For anything beyond the safe checks on this page, use a Gas Safe registered engineer. Find one near you, or check an engineer's ID, on the official Gas Safe Register (free helpline 0800 408 5500).
Can I fix Worcester Bosch FD 231 myself?
Usually, yes. It's normally something you can sort yourself with the checks on this page.
How to reset a Worcester Bosch boiler
Press the reset button (marked with a circular arrow or the word reset) and hold it for a few seconds until the display changes. Only reset once or twice. A code that keeps returning is the boiler telling you something needs fixing.
Sources
We checked this code against the following, last reviewed November 2026. Codes can vary slightly between models, so your boiler's own manual is the final word.