Smell gas? Leave the property and call the National Gas Emergency Service on 0800 111 999, 24 hours.

Vaillant fault code

Vaillant F.23: water not circulating well

Try the checks, then call an engineer

Checked against 2 sources ยท Updated November 2026

What it means

The temperature difference between water leaving and returning to the boiler is too big. Vaillant puts this down to water circulation being too low.

Safe checks you can do

  1. Check the pressure gauge. Find the pressure gauge on the front or underneath the boiler. With the heating off and the boiler cold it should read roughly 1 to 1.5 bar. Anything under 1 bar is low. How to do this
  2. Make sure valves are open. Check that the valves under the boiler are open and that at least some radiator valves are turned on. Water needs somewhere to circulate.
  3. Bleed air out of the radiators. Radiators that are cold at the top have air in them. Bleed them with a radiator key, then check the pressure again, because bleeding lowers it. How to do this
  4. Reset the boiler, once or twice. Use the reset button or reset position on the dial, as your user manual shows. If the same code comes straight back after one or two resets, stop and book an engineer. How to do this

Common causes

  • Low pressure or air in the system
  • Closed radiator or boiler valves
  • A failing pump
  • Sludge build-up

When to call an engineer

If circulation problems keep coming back, an engineer should check the pump and may suggest a powerflush or magnetic filter.

Need an engineer?

For anything beyond the safe checks on this page, use a Gas Safe registered engineer. Find one near you, or check an engineer's ID, on the official Gas Safe Register (free helpline 0800 408 5500).

Can I fix Vaillant F.23 myself?

Sometimes. Try the safe checks on this page first. If the code comes back, you need a Gas Safe engineer.

How to reset a Vaillant boiler

On most Vaillant models press the reset button (the circular arrow) once. Some ranges reset from the menu. Only reset once or twice. A code that keeps returning is the boiler telling you something needs fixing.

Sources

We checked this code against the following, last reviewed November 2026. Codes can vary slightly between models, so your boiler's own manual is the final word.