Smell gas? Leave the property and call the National Gas Emergency Service on 0800 111 999, 24 hours.

Vaillant fault code

Vaillant F.28: boiler failed to light on start-up

Try the checks, then call an engineer
What it means

The boiler tried to light the burner and couldn't. Vaillant's manual describes it as a start-up failure where ignition was unsuccessful, or the gas pressure monitor or thermal cut-out was triggered.

Safe checks you can do

  1. Check you have gas. Try the hob or another gas appliance. If nothing works, check the lever on the gas meter is in line with the pipe (that means on) and, on a prepayment meter, that you have credit.
  2. Check the condensate pipe in freezing weather. The plastic pipe that runs from the boiler to an outside drain can freeze when it's below zero. Thaw it with a hot water bottle or warm water from a watering can, never boiling water, then reset. How to do this
  3. Reset the boiler, once or twice. Use the reset button or reset position on the dial, as your user manual shows. If the same code comes straight back after one or two resets, stop and book an engineer. How to do this

Common causes

  • No gas reaching the boiler: meter off, prepayment credit run out, or a supply problem
  • A frozen condensate pipe in cold weather, which stops the boiler lighting
  • A faulty ignition electrode, gas valve or circuit board
  • Low gas pressure from the supply

When to call an engineer

If you have gas, the condensate pipe isn't frozen, and the code returns after a reset, you need a Gas Safe engineer. Don't keep resetting it.

Need it fixed?

Get a Gas Safe engineer to call you back about Vaillant F.28, or cover future breakdowns with a monthly plan.

Some links are partner links. How we make money.

Can I fix Vaillant F.28 myself?

Sometimes. Try the safe checks on this page first. If the code comes back, you need a Gas Safe engineer.

How to reset a Vaillant boiler

On most Vaillant models press the reset button (the circular arrow) once. Some ranges reset from the menu. Only reset once or twice. A code that keeps returning is the boiler telling you something needs fixing.

Sources

We checked this code against the following, last reviewed November 2026. Codes can vary slightly between models, so your boiler's own manual is the final word.