Potterton fault code
Potterton E119: low water pressure
You can usually fix thisChecked against 2 sources ยท Updated November 2026
Potterton is part of Baxi Group and E119 means the same thing: the water pressure is too low. Top it up to about 1.5 bar on the gauge.
Safe checks you can do
- Check the pressure gauge. Find the pressure gauge on the front or underneath the boiler. With the heating off and the boiler cold it should read roughly 1 to 1.5 bar. Anything under 1 bar is low. How to do this
- Top the pressure up if it's low. Open the filling loop slowly and watch the gauge. Stop at about 1.5 bar, close both valves fully, then reset the boiler. How to do this
- Reset the boiler, once or twice. Use the reset button or reset position on the dial, as your user manual shows. If the same code comes straight back after one or two resets, stop and book an engineer. How to do this
Common causes
- Normal pressure loss
- Recently bled radiators
- A leak
When to call an engineer
Regularly losing pressure means a leak, so book an engineer.
Need an engineer?
For anything beyond the safe checks on this page, use a Gas Safe registered engineer. Find one near you, or check an engineer's ID, on the official Gas Safe Register (free helpline 0800 408 5500).
Can I fix Potterton E119 myself?
Usually, yes. It's normally something you can sort yourself with the checks on this page.
How to reset a Potterton boiler
Press and hold the reset button for a couple of seconds until the boiler restarts. Only reset once or twice. A code that keeps returning is the boiler telling you something needs fixing.
Sources
We checked this code against the following, last reviewed November 2026. Codes can vary slightly between models, so your boiler's own manual is the final word.