Potterton fault code
Potterton E168: general lockout
Try the checks, then call an engineerChecked against 1 source ยท Updated November 2026
A general fault that often follows another code. Look for an earlier code and deal with that first.
Safe checks you can do
- Look for an earlier code. This code often appears after a different fault. If the boiler showed another code first, deal with that one.
- Check the pressure gauge. Find the pressure gauge on the front or underneath the boiler. With the heating off and the boiler cold it should read roughly 1 to 1.5 bar. Anything under 1 bar is low. How to do this
- Reset the boiler, once or twice. Use the reset button or reset position on the dial, as your user manual shows. If the same code comes straight back after one or two resets, stop and book an engineer. How to do this
Common causes
- A previous fault such as low pressure
- Power supply problems
- A failed component
When to call an engineer
If it persists, book a Gas Safe engineer.
Need an engineer?
For anything beyond the safe checks on this page, use a Gas Safe registered engineer. Find one near you, or check an engineer's ID, on the official Gas Safe Register (free helpline 0800 408 5500).
Can I fix Potterton E168 myself?
Sometimes. Try the safe checks on this page first. If the code comes back, you need a Gas Safe engineer.
How to reset a Potterton boiler
Press and hold the reset button for a couple of seconds until the boiler restarts. Only reset once or twice. A code that keeps returning is the boiler telling you something needs fixing.
Sources
We checked this code against the following, last reviewed November 2026. Codes can vary slightly between models, so your boiler's own manual is the final word.