Smell gas? Leave the property and call the National Gas Emergency Service on 0800 111 999, 24 hours.

Glow-worm fault code

Glow-worm F9: pressure sensor, flow filter or pump fault

Try the checks, then call an engineer

Checked against 2 sources ยท Updated November 2026

What it means

On older Glow-worm Ultracom cxi boilers, Glow-worm lists F9 as: pressure sensor, flow filter or pump fault. Newer Glow-worm boilers show codes with a dot, such as F.28.

Safe checks you can do

  1. Check the pressure gauge. Find the pressure gauge on the front or underneath the boiler. With the heating off and the boiler cold it should read roughly 1 to 1.5 bar. Anything under 1 bar is low. How to do this
  2. Top the pressure up if it's low. Open the filling loop slowly and watch the gauge. Stop at about 1.5 bar, close both valves fully, then reset the boiler. How to do this
  3. Reset the boiler, once or twice. Use the reset button or reset position on the dial, as your user manual shows. If the same code comes straight back after one or two resets, stop and book an engineer. How to do this

Common causes

  • The pressure really is too low or too high
  • A faulty water pressure sensor
  • A loose sensor connection

When to call an engineer

If the gauge reads a normal 1 to 1.5 bar and the code stays, the pressure sensor needs replacing by an engineer.

Need an engineer?

For anything beyond the safe checks on this page, use a Gas Safe registered engineer. Find one near you, or check an engineer's ID, on the official Gas Safe Register (free helpline 0800 408 5500).

Can I fix Glow-worm F9 myself?

Sometimes. Try the safe checks on this page first. If the code comes back, you need a Gas Safe engineer.

How to reset a Glow-worm boiler

Press the reset button (the circular arrow) once. If the code returns straight away, don't keep resetting. Only reset once or twice. A code that keeps returning is the boiler telling you something needs fixing.

Sources

We checked this code against the following, last reviewed November 2026. Codes can vary slightly between models, so your boiler's own manual is the final word.