Smell gas? Leave the property and call the National Gas Emergency Service on 0800 111 999, 24 hours.

Fault code, any brand

E119 boiler fault: what it means

Short answer

E119 is a Baxi Group code, also used on Potterton boilers. It means the water pressure is too low.

Boiler codes aren't standard across manufacturers, so check the brand name on the front of your boiler. Here's what E119 means on each brand that uses it:

E119

On a Baxi boiler: low water pressure

The water pressure has dropped too low for the boiler to run. A Baxi Duo-tec tenant guide describes it as the gauge needle reading 0 or below 1, and says to refill to 1.5.

You can usually fix this

Full Baxi E119 guide and fixes

E119

On a Potterton boiler: low water pressure

Potterton is part of Baxi Group and E119 means the same thing: the water pressure is too low. Top it up to about 1.5 bar on the gauge.

You can usually fix this

Full Potterton E119 guide and fixes

First things to check

  1. Check the pressure gauge. Find the pressure gauge on the front or underneath the boiler. With the heating off and the boiler cold it should read roughly 1 to 1.5 bar. Anything under 1 bar is low. How to do this
  2. Top the pressure up if it's low. Open the filling loop slowly and watch the gauge. Stop at about 1.5 bar, close both valves fully, then reset the boiler. How to do this
  3. Reset the boiler, once or twice. Use the reset button or reset position on the dial, as your user manual shows. If the same code comes straight back after one or two resets, stop and book an engineer. How to do this

Need an engineer?

For anything beyond the safe checks on this page, use a Gas Safe registered engineer. Find one near you, or check an engineer's ID, on the official Gas Safe Register (free helpline 0800 408 5500).

Look up a different code