Smell gas? Leave the property and call the National Gas Emergency Service on 0800 111 999, 24 hours.

Glow-worm fault code

Glow-worm F6: heating flow thermistor fault

Needs a Gas Safe engineer

Checked against 2 sources ยท Updated November 2026

What it means

On older Glow-worm Ultracom cxi boilers, Glow-worm lists F6 as: heating flow thermistor fault. Newer Glow-worm boilers show codes with a dot, such as F.28.

Safe checks you can do

  1. Turn the power off and on. Switch the boiler off at the fused spur on the wall for a few seconds, then back on. This restarts the electronics.

Common causes

  • A failed temperature sensor (thermistor)
  • A loose or damaged sensor connection

When to call an engineer

Sensors are usually cheap parts, but they sit inside the boiler, so an engineer needs to test and replace them.

Need an engineer?

For anything beyond the safe checks on this page, use a Gas Safe registered engineer. Find one near you, or check an engineer's ID, on the official Gas Safe Register (free helpline 0800 408 5500).

Can I fix Glow-worm F6 myself?

No. Apart from the simple outside checks here, this needs a Gas Safe registered engineer.

How to reset a Glow-worm boiler

Press the reset button (the circular arrow) once. If the code returns straight away, don't keep resetting. Only reset once or twice. A code that keeps returning is the boiler telling you something needs fixing.

Sources

We checked this code against the following, last reviewed November 2026. Codes can vary slightly between models, so your boiler's own manual is the final word.