Glow-worm fault code
Glow-worm F5: overheating
Try the checks, then call an engineerChecked against 2 sources ยท Updated November 2026
On older Glow-worm Ultracom cxi boilers, Glow-worm lists F5 as: overheating. Newer Glow-worm boilers show codes with a dot, such as F.28.
Safe checks you can do
- Let it cool down. Turn the boiler off and give it 15 to 20 minutes to cool before you reset it.
- Check the pressure gauge. Find the pressure gauge on the front or underneath the boiler. With the heating off and the boiler cold it should read roughly 1 to 1.5 bar. Anything under 1 bar is low. How to do this
- Make sure valves are open. Check that the valves under the boiler are open and that at least some radiator valves are turned on. Water needs somewhere to circulate.
- Reset the boiler, once or twice. Use the reset button or reset position on the dial, as your user manual shows. If the same code comes straight back after one or two resets, stop and book an engineer. How to do this
Common causes
- Water not circulating properly, often low pressure or air
- Radiator or boiler valves closed
- A sticking pump
- Sludge restricting flow
When to call an engineer
If it overheats again after a reset, stop using it and book an engineer to check the pump and circulation.
Need an engineer?
For anything beyond the safe checks on this page, use a Gas Safe registered engineer. Find one near you, or check an engineer's ID, on the official Gas Safe Register (free helpline 0800 408 5500).
Can I fix Glow-worm F5 myself?
Sometimes. Try the safe checks on this page first. If the code comes back, you need a Gas Safe engineer.
How to reset a Glow-worm boiler
Press the reset button (the circular arrow) once. If the code returns straight away, don't keep resetting. Only reset once or twice. A code that keeps returning is the boiler telling you something needs fixing.
Sources
We checked this code against the following, last reviewed November 2026. Codes can vary slightly between models, so your boiler's own manual is the final word.