Smell gas? Leave the property and call the National Gas Emergency Service on 0800 111 999, 24 hours.

Fault code, any brand

F22 boiler fault: what it means

Short answer

F22 (shown as F.22) means low water pressure on Vaillant and Glow-worm boilers. It's one of the easiest faults to fix yourself.

Boiler codes aren't standard across manufacturers, so check the brand name on the front of your boiler. Here's what F22 means on each brand that uses it:

F.22

On a Vaillant boiler: low water pressure

The boiler has shut down because the water pressure in the heating system has dropped too low to run safely. Vaillant's manual says the boiler switches off when the pressure falls below 0.5 bar.

You can usually fix this

Full Vaillant F.22 guide and fixes

F.22

On a Glow-worm boiler: low water pressure

On current Glow-worm boilers, F.22 is a safety switch-off for low water pressure, the same as on Vaillant boilers.

You can usually fix this

Full Glow-worm F.22 guide and fixes

First things to check

  1. Check the pressure gauge. Find the pressure gauge on the front or underneath the boiler. With the heating off and the boiler cold it should read roughly 1 to 1.5 bar. Anything under 1 bar is low. How to do this
  2. Top the pressure up if it's low. Open the filling loop slowly and watch the gauge. Stop at about 1.5 bar, close both valves fully, then reset the boiler. How to do this
  3. Reset the boiler, once or twice. Use the reset button or reset position on the dial, as your user manual shows. If the same code comes straight back after one or two resets, stop and book an engineer. How to do this

Need an engineer?

For anything beyond the safe checks on this page, use a Gas Safe registered engineer. Find one near you, or check an engineer's ID, on the official Gas Safe Register (free helpline 0800 408 5500).

Look up a different code